Loading...
TE-WILBUR OPERATIONS MANUAL REV 002.15 06/11/2015
Tisch Environmental 1-TSP-AND-PM10 sales@tisch-env.com www.tisch-env.com Page 127 of 183
10. Now the controller can be removed by tilting upwards and removing
from the DIN rail.
11. The controller consists of (4) modules:
TE-W-101
Main Controller Module
TE-W-102
Analog input module
TE-W-103
Analog input / output module
TE-W-104
Modbus communication module
12. Each module can be removed or replaced individually. Notice the
latch in the center of the modules. When the latch is in the downward
position, the modules can be pulled apart. When the latch is in the
upward position the modules cannot be pulled apart.
13. Replace each module or entire controller assembly as required. When
modules are all put back together, ensure all the latches are in the
upward position.
14. Place the controller assembly onto the DIN rail. The top must first be
attached, then the bottom can be pushed onto the DIN rail until a
‘click’ is heard denoting the controller is properly seated onto the DIN
rail.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com