Loading...
TE-WILBUR OPERATIONS MANUAL REV 002.15 06/11/2015
Tisch Environmental 1-TSP-AND-PM10 sales@tisch-env.com www.tisch-env.com Page 130 of 183
4. Remove the (2) screws that secure the clamp that secures the pressure
to the sidewall of the enclosure.
5. Unplug the pressure sensor connector and remove the pressure sensor.
6. Remove the tee from the old pressure sensor and install on the new
pressure sensor. Use thread tape on the male thread of the new
pressure sensor to ensure a leak-free seal.
7. Install the new pressure sensor on the sidewall with the clamp and
screws.
8. Plug pressure into pressure sensor connector.
9. Reinstall upper and lower left panels and turn power on.
10. Refer to section 7.8 to zero the pressure sensor.
13.12 Barometric Pressure Sensor Replacement
If the barometric pressure sensor needs replaced, perform the following:
The part number for the barometric pressure sensor is TE-W-154.
WARNING Before opening covers to perform maintenance, ensure unit is
powered down completely. To power down completely, remove mains power
and disconnect the battery at:
MAIN MENU
MAINTENANCE
MENU
BATTERY
DISCONNECT
1. Remove both the upper and lower left plates using a Phillips
screwdriver.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com