Loading...
- 101 - Appendix
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
 
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. The Marvell 9128 SATA controller controls the GSATA3_6/7 ports on the
motherboard. Then connect the power connector from your power supply to the hard drive.


Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Make sure GSATA 6_7/IDE Cntroller under the Integrated Peripherals menu is enabled. Then set GSATA
6_7/IDE Ctrl Mode to IDE or AHCI, depending on your requirements (Figure 1). (In AHCI mode, installation
of the SATA AHCI driver is required during Windows XP installation. Refer to section, "5-1-4" for more infor-
mation.)
Step 2:
To create a RAID array, press <Enter> on the  item (Figure 1) to enter the RAID

Figure 1
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
eSATA Ctrl Mode [IDE]
GSATA 6_7/IDE Controller [Enabled]
GSATA 6_7/IDE Ctrl Mode [IDE]
SATA3 Firmware Selection [Onchip]
  
GSATA 8_9/IDE Controller [Enabled]
GSATA 8_9/IDE Ctrl Mode [IDE]
higf: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com