Appendix - 110 -
B. Installing Windows Vista
The procedure below assumes that only one RAID array exists in your system. Note: You are not required to
9128 controller.
For the Intel ICH10R:
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps.
When a screen similar to that below appears (RAID hard drive will not be detected at this stage), select Load
Driver (Figure 5).
Figure 5
Figure 6
Step 2:
B), then specify the location of the driver (Figure 5). Note: For users using a SATA optical drive, be sure to
to the BootDrv folder and save the whole iMSM
the driver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
For Windows Vista 64-bit, browse to the 64Bit folder.
Method B:
\iMSM\32Bit (for Windows Vista 32-bit) or
\iMSM\64Bit (for Windows Vista 64-bit).
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com