Loading...
4 NAVMAN G-PILOT 3380 System Installation Manual
Important
It is the owner’s sole responsibility to install and use the instrument and transducer/s in a manner
that will not cause accidents, personal injury or property damage. The user of this product is solely
responsible for observing safe boating practices.
The choice, location, and installation of all components in any autoG-PILOT system is critical. If
installation is not correct, the unit can not perform at its designed potential. If in doubt, consult
your Navman dealer. Ensure that any holes that cut are in a safe position and will not weaken the
boat’s structure. If in doubt, consult a qualified boat builder.
Using the G-PILOT 3380 system :
The G-PILOT 3380 system is intended as an aid to save a helmsman from having to steer for
long periods of time, not as the main means of steering the boat.
The G-PILOT 3380 system is not intended for use in extreme weather, in adverse conditions or
in water near other boats, dangerous waters or land.
The G-PILOT 3380 system can not control the boat better than a helmsman. In adverse
conditions steer the boat manually.
Never leave the helm unattended. Keep a watch at all times. The helmsman should always
monitor the course of the boat and the G-PILOT 3380 system and be ready to resume steering
the boat manually.
The performance of the G-PILOT 3380 system can be affected by the failure of a part,
environmental conditions, improper installation and use.
NAVMAN NZ LIMITED DISCLAIMS ALL LIABILITY FOR ANY USE OF THIS PRODUCT IN A WAY THAT
MAY CAUSE ACCIDENTS, DAMAGE OR THAT MAY VIOLATE THE LAW.
As Navman is continuously improving this product we retain the right to make changes to the
product at any time which may not be reflected in this version of manual. Please contact your
nearest Navman office if you require any further assistance.
Governing Language: This statement, any instruction manuals, user guides and other
information relating to the product (Documentation) may be translated to, or has been translated
from, another language (Translation). In the event of any conflict between any Translation of the
Documentation, the English language version of the Documentation will be the official version of
the Documentation.
Copyright © 2005 Navman NZ Limited, New Zealand. All rights reserved. Navman is a registered
trademark of Navman NZ Limited.
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a normal installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an output on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced technician for help.
A shielded cable must be used when connecting a peripheral to the serial ports.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com