Loading...
23
TRACKER 5430/5430i Installation and Operation Manual
NAVMAN
Warning: After creating or changing a
route, display the route on the chart and
check that it does not cross land or dangerous
water.
10-2-1 Creating a new route
A. Creating a new route from the chart display
While creating the route:
Press or to change the range; scroll the
chart by moving the cursor to the edge of
the chart.
A data box at the top, left of the display
shows the route name and total distance. If
the cursor is near a leg, it shows the length
and bearing of the leg as well.
The legs of a route must start and end at
waypoints. If a leg does not start or end at an
existing waypoint then a new waypoint will
be created automatically (to change the new
waypoint data, see section 9-2-7).
1 In the chart display, press MENU and select
New route.
2 The route is given a default name:
i Change the name if necessary.
ii Select Ok.
3 To enter the first leg of the route:
i Move the cursor to the start of the route
and press ENT.
ii Move the cursor to the end of the first leg
and press ENT.
4 To add a waypoint at the end of the route:
i Press ENT.
ii Move the cursor to where the new route
waypoint will be.
iii Press ENT.
5 To insert a waypoint in the route:
i Move the cursor to the chosen leg to
insert the waypoint.
ii Press MENU and select Insert.
iii Move the cursor to where the new route
waypoint will be.
iv Press ENT.
6 To move a waypoint in the route:
i Move the cursor to the waypoint to move.
ii Press MENU and select Move.
iii Move the cursor to where the waypoint
will be.
iv Press ENT.
7 To remove a waypoint from the route:
i Move the cursor to the waypoint to
remove from the route.
ii Press MENU and select Remove. The
waypoint is removed from the route, but
the waypoint is not deleted.
8 Repeat this process until the route is finished.
Review the route and check that the route
does not cross land or dangerous water.
Then press ESC.
Or, to delete the route that is being created:
i Press MENU and select Delete.
ii Select Yes to confi rm.
Tip: The distance and bearing calculator can
also be used to enter a course and save it as a
route (see section 3-2).
B. Creating a new route from the routes display
1 In the routes display, press MENU and select
Create.
2 A new route, with a default name and no
waypoints, is displayed.
3 To change the route name:
i Select the route name at the top of the
display and press ENT.
ii Change the name if necessary.
iii Press ENT.
10-2 Managing routes
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com