Loading...
38 TRACKER 5430/5430i Installation and Operation Manual
NAVMAN
External GPS antenna
(TRACKER 5430)
Fuel transducer(s)
(optional)
Installation
To fuel tank
To engine
Auto Power Wiring
This option is possible on both the TRACKER 5430
and TRACKER 5430i.
Black Wire: Connect this to the negative battery
terminal.
Red Wire: Connect this to the 12 V positive
battery terminal after the main switch. Fit a 1
Amp fuse as shown.
Yellow Wire: Connect to the ignition switch
Fuse
Fuse
White (NMEA out)
Green
External
Beeper or
light
Red
Yellow
Black
Main
switch
12 V DC
Ignition
switch
Fuse Red
Yellow
Black
Main
switch
12 V DC
Basic Wiring
This option is possible on the TRACKER 5430.
Black wire: Connect this to the negative battery
terminal.
Red Wire: Connect this to the 12 V positive
battery terminal after the main switch. Fit a 1
Amp fuse as shown.
Yellow wire: Connect this to the black wire.
Power on the TRACKER manually whenever
the main switch is on.
Power/data cable (black locking collar)
Pin Wire Signal
1 Black Ground (power negative, NMEA)
Note: The cable has two wires with black
coverings, the black wire (pin 1) and the
shield (covered with heatshrink). These
wires are connected within the cable and
therefore it does not matter which black wire
you use.
2 Brown Power out, 12 V DC
3 White NMEA out, to autopilot/radar
4 Blue NavBus - or NMEA2 input
5 Red Positive power in, 8 to 16 V DC
6 Orange NavBus +
7 Yellow Auto power in (connect to positive
power in to enable auto power)
8 Green External beeper or light out,
switched to ground, 30 V DC,
200 mA maximum
Note: Shield is connected to pin 1, black wire
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com