TE-5200 28 Operations Manual
5. Carefully slide quick disconnect tabs into tab slot of new brush.
6. Push brush carbon against armature until brush housing falls into brush
slot on motor.
7. Put brush holder clamps back onto brushes.
8. Make sure quick disconnect tabs are firmly seated into tab slot. Check
field wires for good connections.
9. Assemble motor after brush replacement by placing housing over and
down on the motor (at same time pull power cord out of housing), being
careful not to pinch any motor wires beneath the motor spacer ring.
10. Secure power cord with the cord retainer cap.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com