Loading...
TE-WILBUR OPERATIONS MANUAL REV 002.22 4/27/2017
Tisch Environmental 1-TSP-AND-PM10 sales@tisch-env.com www.tisch-env.com Page 128 of 185
5. The wiring of the Modbus module must now be removed. The Modbus
module is located here:
6. The Modbus module has (2) wires, label each wire and remove them by
unscrewing the terminal and removing the wire.
7. The rest of the wiring is modular and can be removed by grasping each
terminal block in the center and pulling straight out.
8. Now that all the wiring is removed, notice the clamps at the bottom of
the controller. There are (3) of them.
9. Using a small flat-blade screwdriver insert the blade into the hole on the
clamp and push downwards. The clamp will ‘click’ into the open /
downward position.
Clamps
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com