TE-5170DV-BL 21 Operations Manual
Calculate Total Air Volume Using G-Factor
Enter the average temperature of the sample throughout the
sample period in Deg F. The temperature will then be calculated
in Deg K
Enter the average barometric pressure of the sample throughout
the sample period in Inches of Hg. The barometric pressure in
mmHg will then be calculated
Clean Filter
Enter the clean filter pressure in inches of water prior to
Dirty Filter
Enter the dirty filter pressure in inches of water after sampling.
The average sample pressure will then be calculated in mmHg
Enter the total runtime in hours (xx.xx) of the sample
Using the g-factor formula, Po/Pa will be calculated and an average flow rate of the sample will be calculated in
m3/min. Using this information the total sample volume will be calculated.
If you do not have a G Factor, go to TE-5170V High Vol. TSP on www.tisch-env.com
An example of a Volumetric Flow Controlled Sampler Calibration Data Sheet has been attached with
data filled in from a typical calibration. This includes the transfer standard orifice calibration
relationship which was taken from the Orifice Calibration Worksheet that accompanies the calibrator
orifice. The slope and intercept are taken from the Qactual section of the Orifice Calibration Worksheet.
The first step is to convert the orifice readings to the amount of actual air flow they represent using the
following equation:
Qa = 1/m[Sqrt((H2O)(Ta/Pa))-b]
Qa = actual flow rate as indicated by the calibrator orifice, m3/min
H2O = orifice manometer reading during calibration, in. H2O
Ta = ambient temperature during calibration, K ( K = 273 + °C)
Pa = ambient barometric pressure during calibration, mm Hg
m = slope of Q actual orifice calibration relationship
b = intercept of Q actual orifice calibration relationship.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com