Loading...
TE-5170DV TSP VFC 35 Operations Manual
Motor Brush Replacement
(110 volt Brush part #TE-33392)
(220 volt Brush part #TE-33378)
The following steps are accompanied by pictures to aid your understanding of motor brush replacement
procedures. Please be aware that the pictures are standardized and may not exactly match the
equipment that you are using. Motor brush removal and replacement does not change based on motor
or brush type, so do not be confused if your equipment differs from what is pictured.
CAUTION: Unplug the unit from any line voltage sources before any servicing of blower motor
assembly.
1. Remove the VFC device by removing the eight bolts. This will expose the gasket and
the TE-115923 motor.
2. Turn assembly on side, loosen the cord retainer and then push cord into housing and
at the same time let motor slide out exposing the brushes.
3. Looking down at motor, there are 2 brushes, one on each side. Carefully pry the brass
quick disconnect tabs (the tabs are pushed into end of brush) away from the expended
brushes and toward the armature. Try to pry the tabs as far as you can without
damaging the armature.
4. With a screwdriver loosen and remove brush holder clamps and release brushes.
Carefully, pull quick disconnect tabs from expended brushes.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com