Loading...
Rear Panel
The following figure shows the rear panel connectors and buttons.
Figure 3. Rear panel
Viewed from left to right, the rear panel contains the following components:
LED On/Off switch. If this switch is in the Off position, the router’s LEDs, including
the LEDs on the four active antennas, but not the Power LED, are turned off.
Reset button. Pressing the Reset button resets the router.
If the Reset button is pressed for at least 10 seconds and the Power LED blinks white,
the router returns to its factory settings. For information about the factory settings,
see Factory Settings on page 171.
Ethernet ports. Five Gigabit Ethernet RJ-45 LAN ports. Use these ports to connect
the router to LAN devices.
Use Ethernet ports 4 and 5 to cable a device that supports Ethernet port aggregation
to the router. Ethernet ports 1, 2, and 3 are nonaggregate Ethernet ports.
Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the router to an
Internet modem such as a cable modem or DLS modem.
Power On/Off button. Press the Power On/Off button to provide power to the
router.
User Manual13Hardware Setup
Nighthawk AX8 8-Stream AX6000 WiFi Router
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com