Loading...
nThe power turns off (standby mode) immediately
lThe unit was turned on while a speaker cable was shorted.
Twist the bare wires of each speaker cable firmly and reconnect to the unit and
speakers. For details, see the following:
– “Connecting the speaker” (p.18)
nThe unit enters standby mode automatically
lThe sleep timer worked.
Turn on the unit and start playback again.
lThe auto-standby function activated because the unit was not used for the
specified time.
To disable the auto-standby function, set “Auto Power Standby” in the “Setup”
menu to “Off”. For details, see the following:
– “Setting the amount of time for the auto-standby function” (p.105)
lThe speaker impedance setting is incorrect.
Set the speaker impedance to match your speakers. For details, see the following:
– “Changing the speaker impedance setting (SP IMP.)” (p.116)
lThe protection circuitry has been activated because of a short circuit.
Twist the bare wires of each speaker cable firmly and reconnect to the unit and
speakers. For details, see the following:
– “Connecting the speaker” (p.18)
nThe unit is not reacting
lThe internal microcomputer is frozen, due to an external electric shock (such
as lightning or excessive static electricity) or to a drop in the power supply
voltage.
Hold down z (power) on the front panel for more than 15 seconds to reboot the
unit. If the problem persists, disconnect the power cable from the AC wall outlet
and plug it again.
nThe unit cannot be controlled using the remote control
lThe unit is out of the operating range.
Use the remote control within the operating range. For details, see the following:
– “Operating range of the remote control” (p.8)
lThe batteries are weak.
Replace with new batteries.
lThe unit’s remote control sensor is exposed to direct sunlight or strong
lighting.
Adjust the lighting angle, or reposition the unit.
lThe remote control IDs of the unit and the remote control are not identical.
Change the remote control ID of the unit or the remote control. For details, see the
following:
– “Selecting the remote control ID (REMOTE ID)” (p.116)
lThe remote control is set to the Zone B operation mode.
Set the remote control to the Zone A operation mode. For details, see the following:
– “Part names and functions of the remote control” (p.15)
En
120
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com