Loading...
Error indications on the front display
Error indications on the front display
Refer to the following table when the error message is indicated on the front display.
Message Cause Remedy
Access denied Access to the media servers (PCs/NAS) is denied.
Configure the sharing settings and select the unit as a device to which music contents are shared. For
details, see the following:
“Media sharing setup on media servers (PCs/NAS)” (p.68)
Access error
The unit cannot access the USB device. Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
There is a problem with the signal path from the network to the unit.
Make sure your router and modem are turned on, and check the connection between the unit and your
router (or hub). For details, see the following:
“Connecting a network cable (wired connection)” (p.29)
“Preparing wireless antennas (wireless connection)” (p.30)
Check SP Wires The speaker cables are short circuited.
Twist the bare wires of the cables firmly and connect to the unit and speakers properly. For details, see
the following:
“Connecting the speaker” (p.18)
Internal Error An internal error has occurred. Contact the nearest authorized Yamaha dealer or service center.
No content There are no playable files in the selected folder. Select a folder that contains files supported by the unit.
No device The unit cannot detect the USB device. Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Not connected The network cable is not connected. Connect the network cable properly.
The wireless router (access point) is not found. Make sure the wireless router (access point) is turned on.
Please wait The unit is preparing for connecting to the network. Wait until the message disappears. If the message stays more than 3 minutes, turn off the unit and turn
it on again.
RemID Mismatch The remote control IDs of the unit and the remote control are not
identical.
Change the remote control ID of the unit or the remote control. For details, see the following:
“Selecting the remote control ID (REMOTE ID)” (p.116)
Unable to play
The unit cannot play back the songs stored on the iPhone for some
reason.
Check the song data. If it cannot be played on the iPhone itself, the song data or storage area may be
defective.
The unit cannot play back the songs stored on the media servers
(PCs/NAS) for some reason.
Ensure that the files are types that the unit is able to play back. If the unit supports the file format, but
still cannot play back any files, the network may be overloaded with heavy traffic. For information about
the formats supported by the unit, see the following:
“Supported file formats” (p.143)
USB Overloaded An overcurrent is flowing through the USB device. Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Version error Firmware update failed.
Update the firmware again. For details, see the following:
“Updating the firmware (UPDATE)” (p.118)
“Updating the unit’s firmware via the network” (p.133)
En
130
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com