Loading...
Keyboard Stand Assembly
32 YDP-S34 Owner’s Manual
CAUTION
Be sure to attach the anti-fall brackets to the instrument, to
ensure stability. Failure to do so might result in damage to the
instrument or even injury.
3. Secure C.
3-1 Securely tighten the screws on C that were
attached in Step 1-3.
3-2
Attach the caps (
6
) to the head of the screws.
4. Mount A.
Be sure to place your hands at least 10 cm from
either end of A when positioning it.
Align the dowels on D and E with the
corresponding holes on the bottom of A.
CAUTION
Be careful not to pinch your fingers or drop the unit.
Make sure to keep your hands more than 10 cm distant from
the ends of A when positioning the unit, to avoid pinching
your fingers.
Do not hold the keyboard in any position other than the
position shown in the illustration.
5. Secure A.
5-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2 Secure A by tightening the short screws 3
(6 x 16 mm) from the bottom.
6. Connect the pedal cord.
6-1 Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
6-2
Securely wind the cord holder around the
pedal cord.
The cord holder is attached to D.
6-3 Use a vinyl tie (Step 1-1) to take up any
slack in the pedal cord.
2-1, 2-4
2-3
2-2 2-2
D
E
B
Secure the anti-fall brackets (7) using the screws.
C
B
3-2
3-1
DE
A
DEB
At least 10 cm At least 10 cm
5-1
A
A
5-2
Projection of A
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com