Loading...
Table 1. Front panel LED descriptions
LED Description
Power/Check Solid green. The startup is completed, and the router is ready.
Blinking green. The firmware is corrupted (visit http://www.netgear.com/support).
Blinking amber. The firmware is upgrading, or the Restore Factory Settings button was
pressed.
Off. Power is not supplied to the router.
Internet
Solid green. An IP address was received; the router is ready to transmit data.
Solid amber. The router detected the Ethernet cable connection.
Off. No Ethernet cable is connected to the router.
2.4 GHz
Wireless Solid green. The wireless interface is enabled.
Blinking green. The wireless network is communicating data.
Off. The wireless interface is turned off.
5 GHz Wireless
Solid blue. The wireless interface is enabled.
Blinking green. The wireless network is communicating data.
Off. The wireless interface is turned off.
LAN ports 1–4 Solid green. The local port is connected to a 1000 Mbps device.
Blinking green. Data is being transmitted at 1000 Mbps.
Solid amber. The local port is connected to a 10/100 Mbps device.
Blinking amber. Data is being transmitted at 10/100 Mbps.
Off. No link is detected on this port.
USB Solid green. The USB device is accepted by the router and is ready to be used.
Blinking green. A USB device is in use.
Off. No USB device is connected, or the Safely Remove Hardware button was clicked
and it is now safe to remove the attached USB device.
WPS/FastLane Solid green. A WPS-capable or FastLane-capable device is accepted by the router and
is ready to be used.
Blinking green. The WPS-capable or FastLane-capable device can be associated with
the router within two minutes.
Off. No WPS or FastLane connection exists.
Hardware Setup
11
A750 Wireless Dual Band Gigabit Router JR6150
The WLAN and WPS buttons toggle the WLAN and WPS functions on and off, as follows:
Wireless On/Off button. Pressing and holding the wireless LAN button for two
seconds turns the 2.4 GHz and 5 GHz wireless radios on and off. If the Wireless LEDs
are lit, the wireless radios are on. If the LEDs are off, the wireless radios are turned off
and you cannot connect wirelessly to the router.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com