¤Wipe the base station and handset with
a damp cloth (do not use solvents) or
an antistatic cloth.
Never use a dry cloth. This can cause
Contact with liquid
If the handset has come into contact with
1. Immediately switch the handset off
and remove the batteries.
2. Allow the liquid to drain from the hand-
3. Pat all parts dry, then place the hand-
set, with the battery compartment
open and the keypad facing down, in a
dry, warm place for at least 72 hours
(not in a microwave oven, convection
oven, or similar place).
4. Do not switch on the handset again
until it has completely dried.
When it has fully dried, you should be able
to use it again normally.
Questions and answers
If you have any questions about the use of
your telephone, you can contact us at any
time atwww.gigaset.com/customercare
The troubleshooting section (page 15)
contains a list of common problems and
possible solutions.
Recommended batteries
Nickel-metal hydride (NiMH):
The handset is supplied with the autho-
rized AAA batteries.
The display is blank.
1. The handset is not switched on.
¥Press a and hold the End Call key.
2. The batteries are empty.
¥Charge or replace the batteries (page 6).
The handset does not respond to a key press.
The keypad lock is activated.
¥Press and hold the pound key # (page 1).
Base Search and Ä is flashing on the display
1. The handset is outside the range of the base
¥Reduce the distance between handset/
base station.
2. The handset has been de-registered. Please
Register is flashing on the display screen.
¥Register the handset (page 12).
3. The base station is not switched on.
¥Check the base station power cord
(page 6).
Handset does not ring.
The ring tone is switched off.
¥Activate the ring tone (page 14).
The other party cannot hear you.
You have pressed the display key §Mute§ or the
j key. The handset is on hold.
¥Press the left display key to switch on the
microphone again.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com