Network Settings
N600 WiFi Dual Band Gigabit Router
7. Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information with
other routers.
a. Select a RIP direction:
Both. The router broadcasts its routing table periodically and incorporates
information that it receives.
Out Only. The router broadcasts its routing table periodically.
In Only. The router incorporates the RIP information that it receives.
b. Select a RIP version:
Disabled. This is the default setting.
RIP-1. This format is universally supported. It is adequate for most networks,
unless you are using an unusual network setup.
RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the
routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses
8. Click the Apply button.
Your changes are saved.
If you changed the LAN IP address of the router, you are disconnected when this change
takes effect.
9. To reconnect, close your browser, relaunch it, and log in to the router.
Specify the IP Addresses That the Router Assigns
By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The
router assigns IP, DNS server, and default gateway addresses to all computers connected to
the LAN. The assigned default gateway address is the LAN address of the router.
These addresses must be part of the same IP address subnet as the router’s LAN IP
address. Using the default addressing scheme, define a range between and, although you can save part of the range for devices with fixed addresses.
To specify the pool of IP addresses that the router assigns:
1. Launch a web browser from a computer or wireless device that is connected to the
2. Type http://www.routerlogin.net or http://www.routerlogin.com.
A login screen displays.
3. Enter the router user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com