Loading...
The Power LED starts blinking yellow and the configuration is reset to factory default
settings. When the reset is complete, the access point/router reboots. This process
takes about two minutes.
Warning: To avoid the risk of corrupting the firmware, do not interrupt the reset.
For example, if you are connected to the access point/router’s local browser interface,
do not close the browser, click a link, or load a new page. Do not turn off the access
point/router. Wait until the access point/router finishes restarting and the Power LED
turns solid green.
Erase the settings to factory default settings
Caution: This process erases all settings that you configured in the access point/router.
To erase the settings:
1. Open a web browser from a computer or mobile device that is connected to the
access point/router network.
2. Enter http://www.routerlogin.net in the address field.
If you are not connected to the access point/router network but to the same network
as the access point/router, enter the IP address that is assigned to the access
point/router. If you do not know the IP address, see Find the IP address of the access
point/router on page 29.
The Sign-In page displays. You are prompted to sign in with your NETGEAR account.
If the access point/router is not connected to the Internet, you are prompted to sign
in with the local login credentials (see Log in to the access point/router when it is
not connected to the Internet on page 28).
3. Click the Login button.
The NETGEAR Account Login page displays.
4. Enter your registered email address and password and click the LOG IN button.
The BASIC Home page displays.
5. Select ADVANCED > Administration > Backup Settings.
The Backup Settings page displays.
6. Click the Erase button.
A warning page displays.
7. Click the Yes button.
User Manual139Maintain and Monitor the Access
Point/Router
AC2000 802.11ac Wireless Access Point/Router WAC124
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com