Loading...
Factory default settings
You can reset the access point/router to the factory default settings, which are shown
in the following table.
For more information about resetting the access point/router to its factory settings, see
Return the access point/router to its factory default settings on page 138.
Table 3. WAC124 access point/router factory default settings
Default SettingFeature
Login to the local browser interface
www.routerlogin.net (if the access point/router does not get an IP address from a
DHCP server, the IP address is 192.168.0.100)
Login URL
MyNETGEAR registered email address and password
The initial log-in requires SSO and a MyNETGEAR account.
SSO login
admin (case-sensitive, nonconfigurable)
This user name applies only after initial configuration and if the access point/router
is not connected to the Internet.
Local login user name
password (case-sensitive, configurable)
This password applies only after initial configuration and if the access point/router
is not connected to the Internet.
Local login password
System modes
Enabled by defaultAccess point mode
Disabled by default.
Only after you complete the initial log-in process in access point mode, can you
change the mode to router mode and connect the access point/router to an Internet
modem.
Router mode
DHCP settings
Enabled (LAN client in access point mode. WAN client in router mode.)DHCP client
Enabled in router mode (does not apply to access point mode)DHCP server
WiFi network
Enabled for Wireless 1 network
Disabled for Wireless 2 and Wireless 3 networks
WiFi communication
Wireless 1 default network: NETGEAR-1
Wireless 2 optional network: NETGEAR-2
Wireless 3 optional network: NETGEAR-3
SSID names
User Manual257Factory Default Settings and
Technical Specifications
AC2000 802.11ac Wireless Access Point/Router WAC124
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com