10. Specify a new service blocking rule by selecting a protocol, defining the ports, and
defining a name:
•Protocol. From the menu, select the protocol (TCP or UDP) that is associated
with the service or application. If you are unsure, select TCP/UDP.
•Starting Port. In the field, enter the start port for the service or application.
•Ending Port. In the field, enter one of the following:
-If the service or application uses a range of ports, enter the end port for the
-If the service or application uses a single port, repeat the port number that
you entered in the Starting Port field.
•Service Type/User Defined. In the field, enter the name of the custom service
11. Specify which devices on your LAN are affected by the rule, based on their IP
• Only This IP Address. Enter the required address in the fields to apply the rule
to a single device on your LAN.
• IP Address Range. Enter the required addresses in the start and end fields to
apply the rule to a range of devices.
• All IP Addresses. All computers and devices on your LAN are covered by this
By default, the All IP Addresses radio button is selected.
12. Click the Add button.
The new rule is added to the Service Table on the Block Services page.
Router mode: Change a service blocking rule
You can change an existing service blocking rule.
To change a service blocking rule:
1. Open a web browser from a computer or mobile device that is connected to the
access point/router network.
2. Enter http://www.routerlogin.net in the address field.
If you are not connected to the access point/router network but to the same network
as the access point/router, enter the IP address that is assigned to the access
point/router. If you do not know the IP address, see Find the IP address of the access
point/router on page 29.
User Manual93Manage the Firewall and
AC2000 802.11ac Wireless Access Point/Router WAC124