Loading...
Selecting ports
Owner’s Manual 13
Selecting ports
For the METER menu
You can select ports by pressing the (DEC) button or (INC) button. When you do so, the selected port’s LEDs
(+48V/SIG/PEAK for Input, or SIG for Output) is lit for one second. The corresponding location is indicated by a white
frame cursor. The white frame cursor disappears when 10 seconds have elapsed without any front panel operation being
performed. When you once again press the (DEC) button or (INC) button, the white frame cursor appears at the
previous port position.
By long-pressing the (DEC) button or (INC) button, you can jump to the first of every eight ports.
For the GAIN, +48V ON, HPF ON, HPF F, and GC ON menus
You can select the input port or status by pressing the (DEC) button or (INC) button. Output ports cannot be
selected. The parameter display area of the selected input port is highlighted; at the same time, the selected input port’s
LEDs (+48V/SIG/PEAK) are lit for one second. The highlighted indication disappears when 10 seconds have elapsed
without any front panel operation being performed. When you once again press the (DEC) button or (INC) button,
the white frame cursor appears at the previous port position.
By long-pressing the (DEC) button or (INC) button, you can jump to the first of every eight ports.
About port names
For the METER menu
The port name shown in the upper middle of the display can be edited from Dante Controller. A name of up to 31
characters can be specified for each input or output port.
For the GAIN, +48V ON, HPF ON, HPF F, and GC ON menus
The port name shown in the upper line can be edited from Dante Controller. A name of up to 31 characters can be
specified for each input or output port. However, since a maximum of five characters of the port name can be shown in
this menu, “..” is shown following the fourth character if six or more characters have been specified.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com