Loading...
SETUP menu
Owner’s Manual 19
IP ADDRESS, SUBNET MASK, and DEFAULT GW can be edited only if NETWORK MODE is set to STATIC IP. If it is
set to AUTO, the current settings can only be displayed, and not edited.
If Dante Device Lock has been enabled from Dante Controller, it is not possible to change the Dante-related settings
UNIT ID or SECONDARY PORT. If you want to change these settings, use Dante Controller to defeat Dante Device
Lock.
SECONDARY PORT Specifies the operating mode of the Dante secondary port. DAISY CHAIN*,
REDUNDANT
FAN SPEED Specifies the rotation speed of the fan. LOW*,
HIGH
NETWORK MODE Selects the IP address setting mode. This IP address is used when
remotely controlling the unit from a computer, or when updating the
firmware. This is different than the IP address for Dante.
AUTO*,
STATIC IP
IP ADDRESS Specifies the IP address.
(when STATIC IP is specified)
0.0.0.0
In the case of AUTO, the
current value is shown*
SUBNET MASK Specifies the SUBNET MASK.
(when STATIC IP is specified)
0.0.0.0
In the case of AUTO, the
current value is shown*
DEFAULT GW Specifies the DEFAULT GATEWAY.
(when STATIC IP is specified)
0.0.0.0
In the case of AUTO, the
current value is shown*
DIMMER Specifies the time after which the organic EL display goes dark when
the unit has not been operated for a time.
In order to extend the life of the organic EL display, it is designed to go
dark after the specified time.
10sec,
30sec,
1min,
2min,
3min*,
5min
ERROR MESSAGES Specifies whether an error message is shown without dimming the
display when an error/alert occurs.
LIGHT OFF*,
KEEP MESSAGES
BRIGHTNESS Specifies the brightness of the organic EL display.
This can also be adjusted by long-pressing the (DEC) button and
(INC) button for 1.5 seconds or longer, and turning the encoder with
switch.
5%–100%
(adjustable in 5% steps),
70%*
INITIALIZE When you select the memory that you want to initialize, and then press
the encoder with switch, a confirmation appears; press [OK] to execute
initialization.
FACTORY PRESET*,
HA PARAMETERS,
DANTE SETTINGS
Item/parameter Description Values
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com