Loading...
Messages
Owner’s Manual 29
Information Messages
Confirmation Messages
SYSTEM Messages
* If the ID is blank, the message is shown. Otherwise, the ID is shown.
Message Description
FACTORY INITIALIZE IN PROGRESS Started initializing to the factory-set state.
FACTORY INITIALIZE COMPLETED Finished initializing to the factory-set state.
HA MEMORY INITIALIZE IN PROGRESS Started initializing the HA parameters.
HA MEMORY INITIALIZE COMPLETED Finished initializing the HA parameters.
DANTE INTIALIZE IN PROGRESS Started initializing the Dante settings.
DANTE INITIALIZE COMPLETED Finished initializing the Dante settings.
FRONT PANEL LOCKED Started panel lock.
FRONT PANEL LOCKED.
TO UNLOCK - PRESS ALL BUTTONS FOR 3 SECONDS
Panel lock is enabled.
FRONT PANEL UNLOCKED Panel lock was disabled.
Message Description
ARE YOU SURE YOU WANT TO INITIALIZE?
- FACTORY PRESET -
Start initializing to the factory-set state?
ARE YOU SURE YOU WANT TO INITIALIZE?
- HA PARAMETERS -
Start initializing the HA parameters?
ARE YOU SURE YOU WANT TO INITIALIZE?
- DANTE SETTINGS -
Start initializing the Dante settings?
Message ID * Description Possible Solution
NORMAL Starting up normally – – –
DANTE MODULE ERROR! E00-03 An error has occurred in the Dante module. The device has malfunctioned; please contact
a Yamaha service center.
ILLEGAL MAC ADDRESS! E00-04 Because the MAC Address setting has been
damaged, communication is not possible.
The device has malfunctioned; please contact
a Yamaha service center.
UNIT FAN HAS
MALFUNCTIONED!
E00-06 The cooling fan has stopped. Check whether a foreign object might be
caught in the fan. If this does not solve the
problem, contact a Yamaha service center.
MEMORY ERROR! E00-07 Because the internal memory has been lost,
all data was initialized.
If you are using the unit with the START UP
MODE parameter set to RESUME, and
power-cycling the unit does not solve the
problem, please contact a Yamaha service
center.
VERSION MISMATCH! E00-10 The combination of this unit’s firmware and
the Dante firmware is incorrect.
The combination of this unit’s firmware and
the Rio2-native device’s firmware is incorrect.
Match them to compatible versions.
DANTE AUDIO RESOURCE
OVERFLOW!
E00-11 The number of Dante flows has exceeded the
limit.
Re-configure the Dante audio routing, for
example by eliminating unneeded routings, or
by using multicast rather than unicast to
improve the efficiency.
POWER SUPPLY FAILED! E00-13 The supply of power to either power supply A
or B has been interrupted.
Check that the power supply cable is
connected. If checking does not resolve the
problem, contact a Yamaha service center.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com