P/N 7010-0911 12-1
This section describes the procedures necessary to run
3DMC software in 3D mode for an excavator using
TS-1 tilt sensors, two MC-A1 GPS antennas, a radio
antenna, a GX-60 Display, and an MC-R3 Controller.
The TS-1 tilt sensors measure the pitch angle of
various machine elements. Each sensor accurately
measures a gravity referenced angle of the body,
boom, stick, and bucket, sending this angle data to the
GX-60 to provide precise grade. Each sensor is
configured and calibrated for its specific location on
the excavator.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com