Loading...
SVT-4 PRO Bass Guitar Amplifier
11
28. CIRCUIT BREAKER: The SVT-4 PRO
employs an AC line circuit breaker to
help protect against damages due to
excessive current demands. If the
amplifier stops working, check the
circuit breaker.
NOTE: When the circuit breaker opens, the
button will be protruding and showing a
contrasting color. You may reset the circuit
breaker by pushing it in until it latches. The
breaker must cool down for a short time
before the button will latch. If the circuit
breaker opens repeatedly with no signal
input, have the amplifier checked by a
qualified service person.
29. IEC POWER INPUT CONNECTOR:
This is where you connect the supplied
AC power cord.
DO NOT DEFEAT THE GROUND PRONG
OF THE AC PLUG!
30. SPEAKER OUTPUTS:
MONO BRIDGE:
1200W rms @ 8 ohms,
1600W rms @ 4 ohms
This single Speakon® output is for
utilizing the full power output potential of
the amplifier [power amp A summed with
power amp B] for a single mono send.
Stereo / Mono operation is described on
the next page [31].
POWER AMP A:
350W rms @ 8 ohms,
625W rms @ 4 ohms,
925W rms @ 2 ohms
POWER AMP B:
350W rms @ 8 ohms,
625W rms @ 4 ohms,
925W rms @ 2 ohms
Each power amp is capable of achieving
the power output ratings listed above
per side individually; you may use either
side individually or both simultaneously.
Both power amp A and power amp B
provide the choice of utilizing dual
1/4" TS outputs or a single Speakon
output per side [1+, 1–].
When using the 1/4" TS outputs, use
only speaker cables with 1/4" TS ends
to make the connections. Do not use
instrument cables as they may overheat.
We recommend using the Speakon jacks
whenever playing at full output levels.
Make sure the total speaker impedance
load is 2 ohms or greater.
For example, you could connect:
Two 16 ohm speakers (an 8 ohm load),
Two 8 ohm speakers (a 4 ohm load)
or one 2 ohm speaker.
1+ HOT, 1–
BIAMP HIGH
INPUT MONO BRIDGE INPUT
BIAMP LOW/
40 41 42 43 44 45 46 47 48
31 32 33 34 35 36 37
1+ HOT, 1–
29
38 39
30
1+ HOT,1– RETURN
28
(Speakon® is a registered trademark of Neutrik AG.)
The Rear Panel
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com