Loading...
Maintenance
Sonic Tracker II Transducer Replacement
95
P-32+ and P-32 Operator’s Manual P/ N: 1001547-01
The Transducer Replacement Kit includes an “O”-Ring and four replacement screws; however, use the original
screws and keep the four supplied in the kit for replacements in the event one or more are lost.
Figure 171: Remove Screws, Retaining Ring, and “O”-ring
3. Gently pull out the transducer and use a SMALL pair of dikes to gently cut the Ty-Wrap, then remove the
small wire connectors from their tabs (Figure 172 on page 95).
Figure 172: Remove Transducer, Cut Ty-Wrap, and Remove Connectors
4. Place the wire connectors of the new transducer firmly on their tabs; the gray wire connector is placed on
the elevated tab. Place the Ty-Wrap in the slot next to the elevated (gray wire) tab, tighten and trim. DO
NOT pinch the wires (Figure 173 on page 96).
When cutting the Ty-Wrap, be careful not to cut or damage the wires.
CUT
TY-WRAP
CAREFULLY
REMOVE WIRE
CONNECTORS
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com