APPLIANCE ELECTRICAL CONNECTION
The electric connection
must comply with the current legal
Before making the connection, check that:
The system electrical rating and the current outlet are adequate for the maximum power output of the appliance (see the
label applied to the bottom of the casing).
The outlet or the system is equipped with an efficient ground connection in accordance with the current legal standards and
regulations. The manufacturer will not be responsible for the non-compliance with these instructions.
The power cord is supplied with a 15A plug, suitable for the load indicated on the label and a standard 15A GPO.
Letter L (phase) =brown
Letter N (neutral) = blue
Ground symbol =
The power cord must be positioned so that a
of 75°C will not be reached at any point.
Do not use reductions, adapters or splitters since they might cause false contacts and lead to dangerous
to the electric
Use a device that ensures disconnection from the mains in which the contacts are opened to a distance that permits
complete disconnection according to the conditions for over-voltage category III.
The ground wire must not be interrupted by the circuit-breaker.
As an alternative, the electric connection can also be protected by a high-sensitivity residual current circuit- breaker
but this may be subject to nuisance tripping due to residual humidity in hea
It is highly recommended to attach the special green-yellow ground wire to an
cient ground system.
If the power cord is replaced, the ground w i r e
connected to the terminal,
longer than the other wires by about 2
if the supply cord is damaged, it must be replaced by the manufacturer or its service agent or similarly
qualified person in order to avoid a hazard.
TABLE N°3: TYPES OF POWER CORDS
230V 3~ 400V 2N~ 400V 3N~
Only gas burner Gas o
en / Electric
rill 3x1mm² - - -
entilated Electric O
en 3x1,5mm² - - -
gas appliance for domestic use and
safety and CSPR 14