APPLIANCE U SE AN D
ATTENTION: Important Warnings.
For cookers resting on base
ATTENTION: if the cooker rest on a base, take the measures necessary to prevent the cooker from sliding along the support base.
For cookers with electric ovens
ATTENTION: The unit becomes hot during use. Do not touch the heating elements inside the oven.
ATTENTION: The accessible parts can become hot during use. Keep children away from the appliance.
For glass doors
ATTENTION: Do not use harsh abrasive cleaning products or metal spatulas with sharp edges to clean the oven door’s glass since
this could scratch the surface and the glass could break.
For gas cooktops
ATTENTION: Clean burner tops and trivets at least once a week, or after any spillage. Check injectors are not blocked and the
probes and electrodes are clean. Gas inlet pipes should be checked periodically for leakages (see section on leak testing), at
intervals not exceeding 12 months. Lubrication of valves should only be performed by an authorised person, and is required if the
gas control knobs become stiff and difficult to turn.
Do not use steam cleaner to clean the appliance.
WARNING: DO NOT MODIFY THIS APPLIANCE
Please maintain your appliance regularly
maintenance operations, disconnect
the appliance f r o m th e g a s supply and
To replace parts such as knobs and burners, just remove them from the seats without dis assembling any part of the cooker.
To replace parts such as nozzle supports, valves and electric components follow the procedure described in the burner
adjustment paragraph. To replace the valve or the gas thermostat, it is also necessary to disassemble the two rear gas train
brackets, loosening the 4 screws (2 per bracket) that attach it to the rest of the cooker and, unscrew the nuts that attach the
front burner valves to the control support, after removing all the knobs. To replace the gas or electric thermostat, also disassemble
the rear cooker guard, loosening the relative screws, to be able to pull down and reposition the thermostat bulb.
To replace the oven bulb, just unscrew the protection cap that projects out inside the oven (Fig.16).
the appliance from the electric power
The power cord supplied with the appliance is connected to the appliance with an X type connection (in
compliance with standards AS/NZS 60335-1, AS/NZS 60335-2-6 and subsequent amendments) for which it can be installed
without the use of special tools, with the same type of cord as the one installed.
If the power cord becomes worn or damaged, replace it based on the information reported in
able 2. To replace the power cable,
lift the terminal board’s cover and replace the cable.