Loading...
Operating the FC-2500
FC-2500 Operator’s Manual
2-2
Front Panel Components
For information on front panel components, see “Front Panel
Components/Indicators for the FC-2500” on page 1-4 for further
details.
On/Off Button Operations
The On/Off button is located at the bottom-left of the front
panel and functions depending upon the state of the hand-held
computer when the button is pressed and considering the length of
time it is pressed. The following is a list of On/Off button operations:
Cold Boot
• Suspend
Performing a Cold Boot for the
FC-2500
To cold boot the FC-2500, press and hold the On/Off button for about
10 seconds. This action also terminates running applications and
stops serial port operations.
Placing the FC-2500 in Suspend Mode
To place the FC-2500 in Suspend mode, press and release the On/Off
button. Suspend mode allows you to suspend, but not terminate active
applications. In this mode, the display turns off and the FC-2500 stops
serial port operations. For battery-powered units, Suspend mode also
conserves battery power.
To take the FC-2500 out of Suspend mode, press and release the On/
Off button again. The display turns on and the device begins running
any suspended application, but you must restart any serial port
operations. If you attempt to use the FC-2500 before it has completely
resumed operations or use it while it is entering Suspend mode, then
the device will delay three seconds before resuming or suspending.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com