Loading...
17-14
17 CHECK AND ADJUSTMENT
17.4 How to Set the Instrument Constant Value
To set the Instrument constant which is obtained in Section 17.1 “Check and adjusting of instrument
constant”, follow as below.
Note: Each of the Prism mode and Non-prism mode has instrument constant.
Check and adjust in both non-prism and prism modes to obtain an instrument constant for
each.
Operating procedure Operation Display
1While pressing the [F1] key, turn power switch
ON. [F1]
+
POWER ON
2Press the [F2] key. [F2]
3Select the constant value by pressing the [F1] or
[F2] key. [F1] or [F2]
4Enter the constant value. *1),2) Enter value
[F4]
5Turn power switch OFF. Power OFF
*1) Refer to Section 2.6 “How to Enter Alphanumeric characters”.
*2) To cancel the setting, press the [ESC] key.
ADJUSTMENT MODE
F1:V ANGLE 0 POINT
F2:INST. CONSTANT
F3:V0 AXIS P
INST. CONSTANT SET
F1:PRISM
F2:NON-PRISM
INST. CONSTANT SET
NON-PRISM
= - 0.6 mm
--- --- [CLR] [ENT]
INST. CONSTANT SET
NON-PRISM
: - 0.7 mm
INPUT ––– ––– ENTER
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com