Loading...
6-11
6 SPECIAL MODE (Menu Mode)
6.1.4 Area Calculation
This mode calculate the area of a closed figure.
There are two area calculation methods as follows.
1) Area Calculation from Coordinate data file
2) Area Calculation from Measured data
zArea is not calculated correctly if enclosed lines cross each other.
zIt is impossible to calculate what a mix of coordinate file data and measured data.
zIf the coordinate data file does not exist, the area calculation from measured data is done
automatically.
zThe numbers of points used to calculate are not limited.
1) Area Calculation from Coordinate Data File
Operating procedure Operation Display
1After pressing the [MENU] key, press the [F4](P
)
key to get the menu on page 2/3. [MENU]
[F4]
2Press the [F1] key. [F1]
3Press the [F4](P
) key to get the PROGRAMS
menu on page 2/2. [F4]
4Press the [F1](AREA) key. [F1]
5Press the [F1](FILE DATA) key. [F1]
6Press the [F1](INPUT) key and enter the File
Name.
Initial display will be shown.
[F1]
Enter FN
[F4]
7Press the [F4](NEXT) key. *1),2)
The top of the file data (DATA-01) will be set and
the second point number will be shown.
[F4]
8Repeat pressing the [F4](NEXT) key to set
required number of points. [F4]
MENU 2/3
F1:PROGRAMS
F2:GRID FACTOR
F3:ILLUMINATION P
PROGRAMS 1/2
F1:REM
F2:MLM
F3:Z COORD. P
PROGRAMS 2/2
F1:AREA
F2:POINT TO LINE
P
AREA
F1:FILE DATA
F2:MEASUREMENT
SELECT A FILE
FN:_________
INPUT LIST ––– ENTER
AREA 0000
m.sq
NEXT# :DATA-01
PT# LIST UNIT NEXT
AREA 0001
m.sq
NEXT# :DATA-02
PT# LIST UNIT NEXT
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com