Loading...
7-4
7 DATA COLLECTION
7.1.2 Selecting a Coordinate File for Data Collection
When coordinate data in a coordinate data file are used for occupied point or backsight point, select a
coordinate file from the data collect menu 2/2 beforehand.
7.1.3 Occupied Point and Backsight Point
The occupied point and direction angle in the data collect mode are linked with the occupied point and
direction angle in normal coordinate measurement.
It is possible to set or change the occupied point and direction angle from the data collect mode.
Occupied point can be set by two setting methods as follow.
1) Setting from the coordinate data stored in the internal memory.
2) Direct key input.
The following three setting methods for backsight point can be selected.
1) Setting from the coordinate data stored in the internal memory.
2) Direct key input of coordinate data.
3) Direct key input of setting angle.
Note: See 9.4 “Coordinate Data Direct Key Input” and 9.7.2 “Loading Data” for how to store
coordinate into the internal memory.
zExample for setting the occupied point:
In case of setting occupied point from the coordinate data stored in the internal memory.
Operating procedure Operation Display
1Press the [F1](SELECT A FILE) key from DATA
COLLECT menu 2/2. [F1]
2Press the [F2](COORD.DATA) key. [F2]
3Select a coordinate file in the same manner as
Section 7.1.1 “Selecting a File for Data Collection”.
Operating procedure Operation Display
1Press the [F1](OCC.PT# INPUT) key from the
data collect menu 1/2.
The previous data is shown.
[F1]
2Press the [F4] (OCNEZ) key. [F4]
3Press the [F1](INPUT) key and enter PT#.*1)
Press the [F4](ENT) key. [F1]
Enter PT#
[F4]
DATA COLLECT 2/2
F1:SELECT A FILE
F2:PCODE INPUT
F3:CONFIG. P
SELECT A FILE
F1:MEAS.DATA
F2:COORD.DATA
SELECT A FILE
FN:
INPUT LIST --- ENTER
PT#
PT-01
ID :
INS.HT: 0.000 m
INPUT SRCH REC OCNEZ
OCC.PT
PT#:PT-01
INPUT LIST NEZ ENTER
N: 0.000m
E: 0.000m
Z: 0.000m
>OK? [YES] [NO]
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com