Loading...
4 - 10
4.7 Selectting the Display
Five different displays can be selected. These are:
DISPLAY AUTO
Channel number and measured values will appear on the display.
When an alarm occurs, type of alarm will appear.
Every channel will be shown for approximately 2 sec. If the input is greater than the
upper limit of the recording span, – – – – will appear.
If the input is less than the lower limit of the recording span, – – – – – will appear.
Measured Value (5 digits)
Type of Alarm (1 digit)*
Channel Number(1 digit)
*Type of alarm
: high limit
: low limit
: high difference limit
: low difference limit
DISPLAY MAN (except for the 1-pen model)
Channel number, measured values and type of alarm when it occurs will appear on the
display for a specific channel only. This display looks the same as the AUTO display.
The display is updated every two seconds for Pen models and at every measurement
period for Dot-printing model. Using the [CH UP] key, the displayed channel number
will go up.
DISPLAY DATE
Date, including the year will appear on the display. Leap years are provided.
Da
y
MonthYear
DISPLAY TIME
Time will appear on the display.
MinutesHours
DISPLAY OFF
Displays other than status displays will be turned off.
Selecting a screen
Pressing the [DISP] key cycles through the screens in the following order:
AUTO: automatic-mode screen
MAN: manual-mode screen
DATE: date-mode screen
TIME: time-mode screen
OFF: off-mode screen
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com