Loading...
6 - 4
Voltage Measurement Setting (VOLT Setting)
In the case that the measured signal is a DC-voltage, the range can be set as follows:
Key operation Indication Description
Press the [DISP] key for three seconds to enter the SET mode.
Select the [] display by using the [] key.
Then press the [ENT] key.
Use the [] key to select the desired channel.
Press the [ENT] key.
Use the [] key to select [].
Press the [ENT] key.
Select the desired range using the [] keys and press the
[ENT] key.
VOLT Input Ranges
–20.00 to 20.00mV
–60.00 to 60.00mV
–200.0 to 200.0mV
–2.000 to 2.000V
–6.000 to 6.000V
–20.00 to 20.00V
Display Range
Select the minimum value of the recording span (SPAN L)
using the [] and [] keys. Then press the [ENT] key.
The display which appears will allow you to enter the
maximum value of the recording span (SPAN R). Select it the
same way as for the minimum value and press the [ENT] key.
Note that the recording span cannot be beyond the input range,
nor can SPAN L be equal to SPAN R.
[] is displayed and the setting is completed.
Press the [ENT] key to set another channel; or press the
[DISP] key for three seconds to return to the OPERATION
mode.
NOTE If you press the [ESC] key in the middle of setting, the indication returns to the
[] and already set data will be aborted.
PRINT
DISP
ESC
3 sec
PRINT
PRINT
PRINT
CH UP
CH UP
CH UP
CH UP
DISP
ESC
3 sec
PRINT FEED
PRINT FEED
CH UP
CH UP
CH UP
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com