Loading...
7 - 14
7.13
Turning Printing of Channel Numbers On/Off (Dot-printing model)
If turned on, this function prints each channel number next to the measured value at
approximately 25-mm intervals. The default value is ON.
Note that no channel number will be printed if the chart speed exceeds 120mm/h.
SETTING PROCEDURE:
Enter the SET UP mode by turning ON the power while pressing and holding the [CH
UP] (ENT) key until the SET UP display appears.
Use the [ ] key to select the display []. Press the [ENT] key.
Use the [] key to select the display []. Press the [ENT] key.
Using the [] key, select either ON or OFF and then press the [ENT] key. The
display [ ] will appear.
Before leaving the SET UP mode, you have to store your new settings. Use the [] key
to select the [] display, and press the [ENT] key.
Select [ ] to keep your new settings or [] to abort the settings, and
press the [ENT] key. After a few seconds, the OPERATION mode will appear.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com