7 - 18
7.17 Turning the Settings Protection Function On/Off
You can protect your settings made in the SET or SET UP modes using a password.
If you select OFF’:
the choice does not affect operation in any mode.
If you select ON’:
you must type in a password to enter the SET or SET UP mode. The password
discussed here is one you set in the following procedure.
The initial value is OFF.’
Enter the SET UP mode by turning ON the power while pressing and holding the [CH
UP] (ENT) key until the SET UP display appears.
Use the [] key to select the display []. Press the [ENT] key.
Use the [] key to select ON or OFF. Press the [ENT] key. In the case you
selected Off, the setting is completed.
Set a password in four-digits numerals using the [] key and the [] key. After
setting is finished, press the [ENT] key. The display [] appears.
NOTE Never forget the password.
Before leaving the SET UP mode, you have to store your new settings. Use the [] key
to select the [] display, and press the [ENT] key.
Select [] to keep your new settings or [] to abort the settings, and
press the [ENT] key. After a few seconds, the OPERATION mode will appear.
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com