Loading...
x
Table of contents
Chapter 1 – Introduction 1
Chapter 2 – Implement Setup 3
2.1. Enabling ISOBUS 4
2.2. Setting up a new implement 7
2.3. Setting implement geometry 9
2.4. Setting up section control 11
2.4.1. Enabling section control 11
2.4.2. Setting timing 11
2.4.3. Setting up the section switch 12
2.5. Setting up master switch and speed 13
Chapter 3 – Athene Setup 15
3.1. Switching between setup and operation screen 15
3.2. Opening the Athene UT window 16
3.3. Athene primary screens 18
3.3.1. Main screen 18
3.3.1. Spreader settings screen 23
3.3.1. Totals screen 27
3.4. Setting up units 28
3.5. Load cell configuration 29
3.5.1. Load cell calibration 31
3.6. Setting up working width 32
3.7. Setting up pre-start 33
3.7.1. Operating pre-start 34
3.8. Setting up boundary reduction 35
3.8.1. Operating boundary reduction 36
3.9. Setting up products 37
3.10. Setting up alarms 39
3.11. Setting up forward speed 40
3.11.1. SSF Autocal 40
3.11.2. Simulated speed 41
3.12. Adding product / tare 42
3.12.1. With load cells 42
3.12.2. Without load cells 42
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com