Chapter 2 – Implement Setup
2.4. Setting up section control
Follow these steps to set up section control for the implement.
2.4.1. Enabling section control
To use Auto Section Control, this must be enabled.
1. Select System /Features /Implement and set
AUTO SECTION CONTROL to Enabled.
2. If using VRC prescription maps, select VARIABLE RATE
CONTROL, choose Enabled and confirm.
3. Repeat for each feature you wish to enable or disable.
2.4.2. Setting timing
These settings set the response times for the sections when switched on
or off. It is important to accurately calculate the response times to avoid
overlaps or gaps in product application.
To calculate the response times:
1. Ensure the implement is ready to begin product application and that
the product calibration has been performed (refer to Calibration,