Loading...
14
1. Run the cable from the Probe to the connector labeled Probe Input.
2. Wire the Power Supply as shown in Table 3-2.
3. Wire the three 4 to 20 mA Analog Outputs and Alarm Relays as shown in Table
3-2 if desired.
4. Connect to the RS232C Serial Port at J6 if desired.
Table 3-2 Electronics Unit Wiring Table
ITEM CONN. TERM.
Power Supply (+) J8 2
Power Supply (-) J8 1
Analog Out 1 (+) J9 1
Analog Out 1 (-) J9 2
Analog Out 2 (+) J9 3
Analog Out 2 (-) J9 4
Analog Out 3 (+) J9 5
Analog Out 3 (-) J9 6
Alarm Relay 1 J2 1
Alarm Relay 1 J2 2
Alarm Relay 2 J2 3
Alarm Relay 2 J2 4
Table 3-3 J6 Wiring Table
DB-9 SERIAL CONNECTOR ITEM
Pin 2 TX
Pin 3 RX
Pin 5 RTN
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com