Loading...
26
6.1.3 SENSOR REASSEMBLY
Carefully plug the new sensor circuit board into the socket, noting that it is installed at
the correct angle and properly aligned. Using a small screwdriver in the hole near the
tip, press it down sufficiently so that it is fully inserted in the socket.
Install the bushing in the
direction shown in Figure 6-2.
Then install the spring, O-ring,
and the sintered filter. Finally,
while pressing on the end of the
sintered filter to compress the
spring, snap the retaining ring
back into the slot on the inside
of the sensor shield. Be sure
that it is inserted completely, so
that it will securely retain the
sensor components in place.
F
i
g
u
r
e
6-2 Sensor Exploded View
For the HX85 and HX86 series only, not for the
HX85A or HX86A series
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com