Loading...
1
HX80 SERIES
QUICK STARTUP GUIDE – Page 1
STARTUP
WHEN USING PROBE ONLY:
1. Mount the Probe in position to measure the desired gas.
2. Connect Probe wiring by cutting off connector or using a mating
connector, as shown below:
ITEM RIBBON CABLE WIRE #
Power Supply – Pos. 7
Power Supply – Neg. 1 (blue tracer)
Output 1 – Pos. 2
Output 2 – Pos. 6
Output 3 – Pos. 8
Output Common 4
Serial Output – TX 5
Serial Output – RX 3
Notes: Connect only the Outputs desired. See drawing in the HTPB Manual for
further connection details.
Do not apply DC Power until all wiring is completed.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2020 Rsmanuals.com