Loading...
– 33 –
USING #70 RELAY MENU MODE
General Information
Ask your installer if this
feature is active in your
system.
Your system may be set up so that certain lights or other devices can be turned on or off by
using the #70 command from either an Alpha keypad or a telephone keypad (if voice
module is used).
To activate relays from an Alpha keypad, enter 4-digit security code + [#] +70. Follow
the keypad prompts described below.
To activate relays using a telephone and voice module, first dial the 2-digit phone
access code. When the system acknowledges the access, enter 4-digit security code + [#]
+ 70. The following prompts/voice responses will begin.
ENTER DEVICE NO.
00=QUIT 01
Voice: "ENTER DEVICE CODE NOW"
Enter the 2-digit number of the device to be activated.
Note that if an invalid number is entered, the system will simply
ask you to reenter the number.
NN DEVICE IS OFF
HIT 0 = OFF, 1 = ON
Voice: "
voice descriptor
DEVICE nn ON/OFF. FOR
voice
descriptor
ON, ENTER 1, FOR
voice descriptor
OFF, ENTER 0"
Press 0 or 1 to turn the device off or on respectively. "nn"
represents the 2-digit device number and
voice descriptor
is
the relay voice descriptor programmed by the installer.
NN DEVICE IS OFF
HIT THE * KEY
Voice: "
voice descriptor
DEVICE nn ON/OFF. TO EXIT ENTER
00 NOW"
From a keypad, press * to continue. The “Enter Device No.” prompt will appear.
From a telephone keypad, enter “00” to exit, or enter the next relay number to be
programmed. The current on/off state of that relay will be annunciated as described above.
Alternatively, if 6 seconds elapses with no key depression, the voice module will annunciate
the "Enter Device Code Now" message.
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com