Loading...
2 - 15
2 Starting a Sample System
EtherCAT Communication Unit USER’S MANUAL (I574-E1)
2-5 Mounting and Wiring for the EtherCAT
Communication Unit
2
2-5-1 Mounting the EtherCAT Communication Unit on the MX2 Inverter
1Mount the EtherCAT Communication Unit onto the location where the inverter optional board
cover that you removed was attached. Check that the connector is firmly connected.
Note: When the EtherCAT Communication Unit is mounted, the main circuit and control circuit
terminals of the inverter are hidden. For this reason, be sure to wire the main circuit and control
circuit terminals before mounting the EtherCAT Communication Unit.
2Tighten the mounting screw of the EtherCAT Communication Unit.
Tighten the bottom right screw of the EtherCAT Communication Unit with the specified torque
(46 N•cm, 4.7 kgf•cm).
Mounting the EtherCAT Communication Unit onto the inverter
STOP
RESET
RUN
Hz
A
ALM
PRG
3G3MX2
INVERTER
RUN
PWR
SYSDRIVE
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com