Loading...
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-
driver , wire cutters and rubber mallet .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. Note: Use the PART IDENTIFICATION CHART on
page 23 to identify small parts used during assem-
bly. Do not plug in the power cord until all assembly
steps are completed.
With the help of a second person, carefully tip the
treadmill onto its left side as shown. Partially fold the
Frame (12) so that the treadmill will be more stable. Do
not fully fold the treadmill until it is completely as-
sembled.
Attach four Base Pads (97) to the bottom of the Base
(115) with four 1” Tek Screws (108) (three are shown).
2. Identify the Right and Left Uprights (82, 122); the Right
Upright has a half circle cutout in the lower end. The
brackets on the Uprights should face each other.
Hold the Right Upright (82) near the Base (115). Orient
the Right Upright as shown, with the post on the indi-
cated side. Straighten the Wire Harness (34), and feed it
into the lower end of the Right Upright and out of the
upper end. Leave enough slack in the lower end of the
Wire Harness so that it lies flat on top of the Base (see
drawing 3). Make sure that the Wire Harness goes
through the cutout so that it will not be pinched, and hand
tighten two 2 1/2” Bolts (124) with Washers (123) into the
bottom of the Base and the lower end of the Right Upright.
Do not tighten the Bolts yet.
Attach the Left Upright (122) as described above. Note:
There is not a wire harness on the left side.
1
2
97
97
115
12
123
115
124
124
34
Cutout
123
108
97
108
82
Post
122
Brackets
108
3. With the help of a second person, carefully raise the
Frame (12) to the position shown. Be careful not to
overextend the Frame.
Press the lower end of the Shock (105) onto the bracket
on the Base (115) as shown. Press the upper end of the
Shock onto the bracket on the Frame (12). Note: It may
be necessary to move the Frame forward or backward to
align the Shock with the bracket. It may be helpful to use
a flat head screwdriver (see the inset drawing) to lift the
metal clip on the Shock as you press the Shock onto the
bracket. Do not remove the clip.
Carefully lower the Frame (12).
105
115
312
34 105
Clip
6
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com