Loading...
7
5
5. Orient the Handlebar Post (6) as shown. Have a
second person hold the Handlebar Post near the
Frame (2).
See the inset drawing. Locate the wire tie in the
lower end of the Handlebar Post (6). Tie the wire
tie around the connector on the Lower Wire (69)
as shown. Then, pull the upper end of the wire
tie until the Lower Wire is routed through the
Handlebar Post.
Tip: It may be necessary to remove the
Access Cover (92) and insert your fingers
into the Handlebar Post (6) to route the Lower
Wire (69) through the top of the Handlebar
Post.
6
2
92
69
Wire Tie
Wire Tie
Wire Tie
69
6. Tip: Avoid pinching the Lower Wire (69).
Loosen the indicated Post Knob (47) and pull it
outward. Then, insert the Handlebar Post (6) into
the Frame (2).
Move the Handlebar Post (6) upward or down-
ward to the desired position, release the Post
Knob (47) into an adjustment hole in the
Handlebar Post, and then tighten the Post Knob.
Make sure that the Post Knob is engaged in
an adjustment hole.
See the inset drawing. If necessary, insert
the Receiver Wire (101) on the Access Cover
(92) into the Handlebar Post (6), and press the
Access Cover into the Handlebar Post. Then,
pull the Receiver Wire upward out of the top of
the Handlebar Post.
6
Avoid pinching the
Lower Wire (69)
Holes
47
69
2
6
6
92
101
Loading...
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com