1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (55) so that the treadmill is more stable;
do not fully fold the Frame yet.
Locate the Upright Wire (85), which is bundled
at the front of the Base (94). Remove the pack-
aging from the Upright Wire. Insert the Upright
Wire back into the end of the Base and pull it out
of the indicated hole. If necessary, use the tie to
pull the Upright Wire out of the hole.
Hold a Wheel (95) centered in a Wheel Housing
(96). Press a Wheel Axle (97) through the
Wheel. Press the Wheel Housing into the end of
the Base (94) as shown.
Attach the other Wheel (95) in the same way.
2. Attach four Base Feet (92) to the Base (94) in
the locations shown with four #8 x 1" Tek Screws
See the inset drawing. Cut the plastic tie near
the Upright Wire (85).