5. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet
from damage, place a mat under the treadmill.
4. With the help of a second person, carefully tip the
Uprights (82) down as shown. Make sure that the
Extension Legs (103) remain in the Uprights.
Insert a Handrail Bolt (78) with a Handrail Washer (36)
into each Extension Leg (103), and tighten the Handrail
Bolts into the Handrails (85). Note: If it is difficult to thread
the Bolts into the Handrails, pull one of the Handrails to
the side and hand tighten a Bolt into the bottom of the
Handrail. Notice the angle of the Bolt. When attaching
the Handrails to the Extension Legs, insert the Bolts and
Washers at the observed angle. It should be close to the
same angle as the Handrails (see drawing 4b).
Refer to drawing 4c. If it is difficult to align the hole in a
Handrail (85) with the hole in an Extension Leg (103), it
may be necessary to move the Handrail up or down or
have a second person stand on the treadmill and lift the
Refer to drawing 4a. Attach each Extension Leg (103)
with two Screws (101) and a Base Pad (116) as shown.
Note: One replacement Base Pad (116) and Spacer (not
shown) are included. If a Base Pad (116) becomes worn
and needs to be replaced, use the replacement Base
Pad. If a Thick Base Pad (97) needs to be replaced, use
the replacement Base Pad with the Spacer.
With the help of a second person, carefully tip the
Uprights (82) back to the upright position.
3. Slide the upper end of a Handrail (85) into the right
Upright (82) as shown. Note: It will be necessary to
pivot the Handrail to the side and back repeatedly
(see arrow A) while pushing on the Handrail (see
arrow B) to slide it fully into the Upright. Next, pivot
the lower end of the Handrail down, push it toward the
right Upright, and then align it with the indicated hole.
Slide the other Handrail (85) into the left Upright (82) as