Hardware Guide 3
Hardware Specifications
Hardware Description
Device Connections and Buttons
Ethernet Network Interfaces
LAN1: Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps and 802.3at PoE+
connectivity. The WatchGuard AP327X can be powered by an PoE+ connection on the LAN1
interface.
LAN2: Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps. This interface can be
used as a wired extension for a wireless SSID that has NAT enabled. For more information on how to
configure NAT settings for an SSID, see the WatchGuard Wi-Fi Cloud Help.
For APs managed locally by a Gateway Wireless Controller, you can bridge together the LAN ports on
AP models that have two LAN interfaces. This enables you to extend the wired network on the LAN2
interface. For more information, see the Fireware Help.
Reset Button
Resets the WatchGuard AP to factory-default settings.
You must use a Phillips screwdriver to remove the cover screw for the reset button. Use a paper clip
or other small object to press the reset button through the hole.
Press and hold the reset button for up to 10 seconds until all LEDs go off to indicate that the AP has
rebooted
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com