REMOTE CONTROL OPERATING GUIDE (continued)
WARNING
When the RF thermostat is in the “Auto” mode and the room temperature drops below the
minimum temperature, the fire and fan will come on and operate until the room temperature is 3°
above the minimum and then turn off, therefore:
The minimum temperature should be set at a temperature that is not likely to cause the fire
to continually turn on and off.
If leaving the house for an extended period, the RF thermostat should be turned “OFF”.
As long as the RF thermostat is in the “Auto” mode and the temperature goes below the
minimum set temperature, the fire will come on no matter what times are programmed into
the thermostat.
If you are unsure of the operation of the RF thermostat, please contact the manufacturer.
In the event of loss of power, the appliance will shut down safely. The appliance may
automatically resume operation once power is restored, pending the operation mode of the
remote control. 27
Programming
Setting the period starting time
The hour and AM/PM settings will now flash. To set the P1 starting time, press and release
the sor tbutton to increase or decrease the hour setting. Press and hold the sor t
button for 2 seconds or longer to increase or decrease the hour setting by 1 hour every 0.5
seconds.
Please ensure that AM/PM is set correctly.
Press ‘OK’ to accept.
The minute setting will now flash. Adjust the minute setting similarly, using sor tbutton
Press ‘OK’ to accept.
Setting the temperature
The temperature setting will now flash. Press and release the sor tbutton to increase or
decrease the temperature setting by 1 °C. Press and hold the sor tbutton for 2 seconds or
longer to increase or decrease the temperature setting by 1°C every 0.5 seconds.
Press ‘OK’ to accept.
Period 1 is now set for the day/s of the week that you have chosen. The LCD will display to
indicate that Period 2 can now be set for the same day/s of the week.
Repeat the programming process for periods 3 and 4.
After program 4 is set, press 'OK' and the program for the selected day/s will be set.
Repeat the programming process for any other periods/days that are required.
Restore factory default settings
With the thermostat off, press the following sequence of buttons: ‘P’, ‘T’, ‘T’ t.
Teaching RF thermostat ID code to control unit
CAUTION: The thermostat has already been programmed with a unique code. Do not
attempt to teach the RF Thermostat ID code unless instructed by the manufacturer.
With the thermostat off, press the following sequence of buttons: ‘P’, ‘T’, ‘T’ s.
The LCD display will show ‘CL’ (Code Learn) for 2 seconds then return to the normal OFF state
display. During this time a special code will be transmitted by the RF Thermostat to the Control
Unit, causing the Control Unit to learn its ID.
Terms of Use | Privacy Policy | DMCA Policy
2006-2021 Rsmanuals.com